Page 1 of 1

Countdown (Macsen Software) - Inlay and Instructions

Posted: Sat Sep 15, 2018 8:00 pm
by PROSM
I bought the original release of Countdown last year at NERG and decided to scan the inlay and type up the instructions after noticing that the inlay for the Macsen Software release is absent from the archive.

This is the first inlay that I've scanned and I'm not too good with image manipulation software (hence the slightly dodgy cropping), so I have linked the full resolution scan below, so that it can be shrunken down and compressed accordingly for archival.

Countdown Inlay (warning, 6864x2488 10MB JPEG ahead!)
Countdown Instructions (Pastebin link)

Re: Countdown (Macsen Software) - Inlay and Instructions

Posted: Sat Sep 15, 2018 8:27 pm
by PeterJ
Thank you very much [mention]PROSM[/mention] that's great. I'm sure [mention]R-Tape[/mention] will add it to his spreadsheet for upload to ZXDB.

Re: Countdown (Macsen Software) - Inlay and Instructions

Posted: Sat Sep 15, 2018 9:50 pm
by R-Tape
PeterJ wrote: Sat Sep 15, 2018 8:27 pm Thank you very much @PROSM that's great. I'm sure @R-Tape will add it to his spreadsheet for upload to ZXDB.
Aye will do tomorrow. Cheers.