Amazing work, really appreciated snapshot saving was the only thing making me switch back to the original NMI now its not needed. Dropping back to basic is a really handy thing to have too...bob_fossil wrote: ↑Sun May 24, 2020 3:05 pm v0.07Download.
- Initial support for saving snapshots in NMI. Shift + S now saves a 48k/128k .SNA file.
- Initial support for POKEs in NMI. Shift + K lets you enter up to 8 POKES which are then applied when you exit.
- Added support for X8 (28mhz) turbo mode on ZX-UNO (needs EXP27 core). Thanks to azesmbog for supplying the register information to enable this.
- Shift + U now attaches a .TRD file to a virtual device (0-3). The attached devices are shown as 0123 in the bottom status line when attached.
- Rewrote .SNA / .Z80 loading code to work more like the original esxdos NMI to fix reported issues.
- Added setting 'Remember last folder' to BRWSCFG. If you're several levels deep in a folder tree, when you navigate to the parent folder, the highlight will be put on the folder you were just inside rather than back at the start of the entries for that folder.
- Added additional delay for keypresses when moving the selection and not scrolling to make it less 'twitchy'.
- Shift + L will now exit the browser and auto type the selected filename into BASIC (.dot command only).
- Shift + F will now show information about the selected file.
- Shift + I / O will attach the selected .TAP file to tape input / output.
Edit: unfortunately I cant download/test it as my broadband has been out since yesterday ☹
As soon as I'm back up and running (I'm told wednesday) I will give some feedback..